Knowledgebase: VeCOAX MiniMod-2
** VECOAX MINIMOD MANUAL **
Posted by PVI Engineers, Last modified by PVI Support on 11 December 2018 05:37 PM

READ HERE FIRST:  DO NOT CONNECT ANY HDMI VIDEO SOURCE AT FIRST!
Simple leave the video input of the modulator disconnected and search for the channel on your tvs so it will display our logo.
After you found the channel and see our logo, then connect your video source and make sure it is set as per the manual.
For directTV see the directv suggested settings by searching directv on this site search.


FIRST TEST > Connect the Modulator DIRECTLY to one of yours TVs with a short piece of coaxial cable, and find the channel on that TV>
There is no need to connect any video source at first, and search for the channel ( shipping default is usa qam cable mode ).
When you find the channel on your TV, and see our logo, You can then move the modulator to the final location and test again on the same tv.
USE THE FIRST TEST TV as a tester to troubleshoot any receiving point / room socket of your coax distribution if necessary to find any cable signal loss if any.


If you are using QAM MODE ( your TV ANTENNA is set to USA CABLE MODE ) select QAM64 in case your cables are very long and you have many splitters that might lose too much signal.
QAM64 or QAM256 does not change the audio/video quality, and QAM64 is always better on longer cables, interferences, older coaxial systems and distribution boxes.
Use QAM256 only if your TV cannot receive QAM64 cable mode.


Please follow the video manual and the PDF Manual here below for more detailed information and customization as you need.

 

********* VIDEO MANUAL *******************

VIDEO MANUAL > PLAY HERE


********* PDF MANUAL *********************

PDF MANUAL DOWNLOAD LINK HERE BELOW

 

 ****************************************

tags

mini mod minimod2 minimod 2



Attachments 
 
 Compact RF Series Manual.pdf (983.23 KB)