VuMatrix Smart Controller
Posted by PVI Support, Last modified by PVI Support 202 PVI Support 202 on 19 June 2019 02:25 PM

The Default Wifi Name for the Smart Controller is
Vumatrix

And the password is  "PVI12345"

 

If you need to factory reset the unit


The reset procedure works as followed:

- Open the top cover and look for the switch labeled SW2
- Reset possible only in de-energized state
- Press and hold SW2 and switch on the power supply.
- after 2 seconds the LED lights up for approx. 15 seconds and then starts to flash.
- after the sixth flashing, the LED stops flashing, then lights again for 15 seconds and so on.
- During the blinking frequency, ie after about 20 seconds, the reset button can be released.

A reboot (off / on) is usually not necessary but can be done.

 

The unit will then default to the factory Wifi Name and Password.